Flip the switch and hear your garbage disposal hum without grinding anything? That hum is actually good news. It means the motor is getting power but the grinding plate is jammed, and freeing a jam is one of the easiest appliance fixes there is.
Here is why a disposal hums and how to get it spinning safely.
This article will teach you:
- What the humming tells you
- How to clear a jam safely
- Where the reset button is
- When the motor has failed
Why the Disposal Hums
A humming disposal has power but cannot turn. The usual causes are:
- A jammed flywheel, often from a bone, seed, or utensil wedged against the grinding plate.
- A tripped reset button that shut the motor down after an overload.
- Hardened debris binding the impellers.
- A failing motor, which is the least common cause.
What You’ll Need
- The hex wrench that came with the disposal
- A flashlight and tongs
- Your owner’s manual
How to Free a Humming Disposal
Turn the disposal off at the switch before you begin.
- Cut the power. Switch the disposal off and never put your hand inside the chamber.
- Free the flywheel. Insert the hex wrench into the socket on the bottom of the unit and work it back and forth to break the jam loose.
- Remove debris. Use a flashlight and tongs to pull out anything wedged in the chamber.
- Press reset. Push the red reset button on the bottom, then restore power and test.
Pro Tip: Never reach into the disposal with your fingers, even with the power off. Use the hex wrench from below and tongs from above to clear jams safely.
When to Look a Little Deeper
Because a jam and an overload often go together, it helps to know the reset and drainage basics, and reviewing the garbage disposal reset button or how to check disposal drainage can prevent repeat jams. Odors that follow a jam tie into cleaning the splash guard.
If the flywheel or internals are damaged, you can learn what happens when a disposal flywheel fails, or how to take a disposal apart for repair.
When to Call a Pro
If the flywheel turns freely and the reset is set but the disposal only hums, the motor may be failing. Replacing a disposal involves plumbing and wiring, so call a pro if you are unsure.
Wrapping Up
A humming disposal is almost always a simple jam. Here’s the recap:
- Switch off the power first.
- Free the flywheel with the hex wrench.
- Clear debris with tongs, never your hand.
- Press the reset button and test.
Free the jam and your disposal usually roars right back to life. You’ve got this.