Many washers lose cleaning power when the agitator starts to wear out. The Kenmore washer top agitator can be replaced with a few basic tools and a bit of time. This guide walks you through what you need, how to stay safe, and what to expect during the process.
What You Need
- 7/16 socket and extension
- Pliers
- Replacement top agitator compatible with your washer model
Safety Precautions
- Turn off the washer and unplug it from the power source before starting any work
- Shut off the water supply at the outlet to prevent leaks
- Let the washer cool down if it was recently used
- Work slowly and carefully to reduce the risk of injury
- Use a well-lit space so all parts are easy to see
- Keep the area clean and free of clutter
- Keep children and pets away from the workspace
- Keep hands dry while working on internal parts
- Review the user manual for model-specific instructions
- Handle parts gently to avoid damage
- Wear insulated gloves to protect your hands
- Avoid contact with exposed wires or terminals
- Use safety glasses or a dust mask when dealing with dust or debris
Why The Kenmore Washer Top Agitator Fails
The top agitator can wear down over time due to regular use. Plastic parts inside may become smooth or loose, which affects movement during the wash cycle. In some cases, buildup from detergent or debris can also cause poor performance. Replacing the part helps restore proper motion and improves cleaning results.
Signs You Need To Replace The Top Agitator
- The top section spins freely in both directions
- Clothes are not moving properly during the wash cycle
- The agitator feels loose or unstable
- Unusual noises occur during agitation
How to Replace a Kenmore Washer Top Agitator
Follow these steps to remove the old top agitator and install a new one safely and correctly.
Preparation
- Turn off the washer and unplug it from the power source
- Shut off the water supply connected to the washer
- Lift the washer lid to access the agitator
Remove Cap and Dust Cap
- Locate the cap on top of the agitator and pull it straight up, then set it aside
- Look inside the agitator and find the dust cap with a rubber seal
- Pull out the dust cap by hand or use pliers to grip and remove it if needed
Remove Bolt and Old Agitator
- Find the 7/16-inch bolt inside the agitator
- Use a socket with an extension to loosen the bolt by turning it counterclockwise
- Hold the lower agitator to keep it from spinning while loosening the bolt
- Remove the bolt completely and set it aside
- Pull the old top agitator straight up and remove it
- Turn the agitator over to release the cam and agitator dogs
Install New Top Agitator
- Place the cam assembly into the new top agitator
- Align the new top agitator with the lower section and push it into place
- Insert the 7/16-inch bolt and tighten it by turning it clockwise
Reassemble and Test
- Reinstall the dust cap back into the agitator
- Put the top cap or fabric softener cap back on
- Turn the water supply back on
- Plug the washer back in
- Run a short cycle to check that the agitator works properly
Closing Thoughts
A worn part can make a washer feel weak, but the fix is often simple. The Kenmore washer top agitator is designed to be removed and replaced without special tools or advanced skills. Once the new part is in place, you can expect better movement inside the drum and cleaner laundry after each cycle.
Take your time during the process and keep your workspace safe and organized. Small steps and careful handling go a long way in getting the job done right. A quick test run at the end helps confirm that everything is working as it should.
This type of repair helps extend the life of your washer and keeps it running the way it should. Clean clothes and smooth operation are a good sign that the new agitator is doing its job.